AC Installation in Amarillo, TX

AC Replacement Done Right for High Plains Homes

Installing an air conditioner in Amarillo isn't the same job as installing one in Houston or Dallas. At roughly 3,600 feet on the High Plains, our air is thinner and drier, our summers hit triple digits, and our winters drop well below freezing — sometimes in the same week. A system that isn't sized and configured for this climate will short-cycle in July and struggle in January.

We start every install with a Manual J load calculation based on your actual house — square footage, insulation, window exposure, duct condition — not a guess based on the old unit's tonnage. Oversized systems are the most common installation mistake we see in the Panhandle: they cool fast, shut off early, and leave the house clammy while wearing out the compressor years ahead of schedule.

On install day, we protect your floors, recover the old refrigerant properly, set the new condenser level on a fresh pad with clearance for our wind-driven dust and tumbleweeds, pressure-test the lines, pull a deep vacuum, and verify the charge by superheat and subcooling. Then we walk you through the thermostat and the warranty before we leave.

Every Installation Includes

• Manual J load calculation — sized to your home, not the old unit
• Flat-rate written quote with equipment, labor, and permits itemized
• Proper refrigerant recovery, new pad, and line-set inspection
• Airflow and charge verification before we call it done
• Manufacturer warranty registration handled for you

Whether you're replacing a 20-year-old builder-grade unit in a Puckett ranch or putting the first system into a barndominium going up outside Bushland, we'll give you honest options at honest prices — and we'll never push a replacement when a repair makes more sense.